News & Announcements
In this section we inform you about new developments, exhibition and more.
11. July 2022
Our office is closed from July 25th until August 14th, 2022.
Plese Note: We do not accept goods in the holiday time
4. December 2019
Please understand that we can no longer provide support for the evaluation software of the TTT Tapping Torque Test System WinPCA up to version 3.7. These versions are not compatible with Microsoft Windows 10.
Information on the newly developed successor software TTT-System PCA 4 can be found here. We will be happy to send you an offer for the update.
30. September 2019
After one year of development we released TTT-System PCA 4.1. Many small improvements were implemented. The performance was much improved, especially for big projects.
Most notable other improvements are:
New in 4.1:The SumCut values are not visible in the Measure mode already. The dashed line represents the average over all other curves.
New in 4.1: Now with configurable content. It is possible to include all line graphs from all cuts. Further you can disable some charts if you don’t want them.
17. December 2018
Our office is closed from December 24th 2017 until January 4th, 2018. We wish you a merry christmas and a happy new year.
Plese Note: We do not accept goods in the holiday time.
6. September 2017
Europe’s largest international conference on tribology and lubrication. The microtap GmbH will participate in this conference with a lecture. More information